Tash-limited 51150 User Manual

SCATIR Switch User Guide Model # 51150 SCATIR Switch with Sensor Model # 51200 SCATIR Switch with Eyeglass Mounting Kit Model # 51250 SCATIR Swi

105. Auditory Tone The switch incorporates an auditory tone which emits a beep when the switch is activated. This auditory feedback can be enabled

11Power Rechargeable Battery To recharge the Nickel Metal Hydride (Ni/MH) battery in the SCATIR switch, plug the power unit into the charger jack

12Mounting 1. Gooseneck Mounting Option The SCATIR switch gooseneck sensor is equipped with a standard 5/8 – 27 thread. The kit comes with a vari

132. Eyeglass Mounting Option This kit comes with the sensor clamped in a typical position on a set of eyeglass frames. The eyeglass mounting may

14The angled-head sensor is constructed so that the wire leads and the plastic insulation may be bent. Imbedded in the right-angle sensor is soft wi

2Table of Contents Introduction page 3 Description Front of Sensor Box page 4 Back of Sensor Box page 5 Bottom of Senso

3Introduction The Self-Calibrating Auditory Tone Infrared (SCATIR) Switch is a multi-purpose momentary-contact optical switch with auditory feedbac

4Description 1. Front of Sensor Box Relay Out: Plug the relay cable into this port. It connects directly to the

52. Back of Sensor Box 12/24 VDC: Plug the 12V charger into this port to charge the internal 9V rechargeable battery.

63. Bottom of Sensor Box Dip Switches: These switches are used to control the tone, the sound of the tone and the calibration mode. Set Switc

7Operation 1. Dip Switches On the bottom of the unit you will find 4 dip switches or four small white switches. These switches are used to contro

83. Self Calibrating Mode When the switch is being activated by a body part that cannot always maintain a constant activation distance from the se

9 4. Manual Calibrating Mode When in manual calibrating mode, the activation distance is set by the user. 1. Turn the sensor box off. 2. Set